DIY Tiered Tassel Earrings

DIY Tiered Tassel Earrings

Just as my wardrobe has become more minimal, my earrings have become… well, maximal! I have clear memories of feeling quite glamorous as a kiddo with pierced ears wearing my mother’s oversized earrings leftover from the ’80s. But then there was a span of about twenty years when, as my fashion sense developed, earrings felt a little too gaudy. Well, that is with the exception of my minimal silver hoop earring phase at the turn of the century. (They went well with my flared jeans and Abercrombie tees!)

Lately I’ve found myself surprised by my interest in the oversized earrings I’ve seen dangling on the ears of fashionable ladies all over the web. I decided I was ready for the earring revival, and I was going to jump in with both feet– and with a DIY take on the statement earring trend.

DIY Tiered Tassel Earrings

DIY Tiered Tassel Earrings

statement earring DIY

DIY Tiered Tassel Earrings

statement earring DIY

Step One: Remove the paper from one embroidery floss bundle and fold it in half. Use an approximately 12″ strand from the extra embroidery floss bundle to tie it tightly in the middle and the knot it.

Step Two: Cut through the loops at either end of the bundled floss.

DIY Tiered Tassel Earrings

Step Three: Pull the either end of the tied bundled downward and secure tightly as shown above with a strand from the extra embroidery floss bundle. I tied it once on one side, flipped it over and tied it again, then flipped it over and tied in a knot. 

DIY Tiered Tassel Earrings

Step Four: Use a darning needle to thread the two ends of the floss you just tied into the tassel and out the bottom.

Step Five: Give your tassel a haircut to make it even on the bottom and the size that you desire. You will need very sharp fabric scissors to do this well.

DIY Tiered Tassel Earrings

Repeat steps 1-5 until you have created 6 tassels as shown above.

DIY Tiered Tassel Earrings

Step Six: Arrange your tassels in two rows of three, making sure each row’s tassels are evenly sized compared to the row of tassels beside it. Use a darning needle to hide the top knot strands of the top two tassels in each row, trimming them to be the same length as the tassel. Leave only one strand untucked on the bottom tassel of each row, but tuck the other one in.

Step Seven: Use the remaining strand from the bottom tassel to connect the entire row of tassels. To do this, thread the strand through a darning needle and use the needle to guide the thread through the bottom of each tassel and up through the middle of the tassel’s top.

DIY Tiered Tassel Earrings

Step Eight: Knot the thread tightly around the eye of the ear wires, making sure to get the ear wire tight up against the top of the tassel. Then use the darning needle to hide the remaining strand of embroidery floss down into the tassels. Trim it to blend in nicely.

DIY Tiered Tassel Earrings

I was so excited about these earrings that I made two pairs right away– one in black yarn, then these in ecru embroidery floss. I wore them to church over the weekend (paired with a simple black shift dress and nude clogs) and had a lot of fun conversations about them, as you can imagine! I guess that’s why they’re called statement earrings– they practically require a reaction!

What do you think? Are you ready for the return of statement earrings, or are you happy to leave the trend in the annals of the ’80s?

7 Responses

  1. I’ve just learnt how to make tassels in an embroidery then your diy is great for me to go on this trend! ;)

  2. Jadie says:

    I have been on the hunt for this exact earring, and it never crossed my mind to make it! DUH! Love, love, love, Heading to the craft store tomorrow! Thanks for the inspo, lady!

    • Mandi says:

      haha! I had been too, and honestly I wouldn’t have tried to make them (because I’ve been in a craft slump lately) except they were SO expensive! :)

  3. Jojo says:

    I love these! Are they heavy? I adore big earrings, but I hate heavy ones…Migraine probs!

    • Mandi says:

      I made a pair from yarn that were heavier. These didn’t pull, but when I wore a denim jacket with them the earrings kept getting in the way when I turned my neck when driving. It was fine without the jacket, though. Anyway, if you’re worried about the weight, you can make the tassels half as thick by tying the tassel at the natural bend in the embroidery floss bundle, rather than folding the bundle in half as I showed here.

  4. Laura says:

    these are really cute! xx

Leave a Reply